Hello,
I just setup my machine and am to the section where you home the machine for the first time '$h'
I am connected on COM 3 and can get a response from the arduino (appears to be a grbl shield for motion control?) Anyway I am passing the 2 $h and seeing the warning but am not getting motion. grbl settings all reply over com $ works and all that jazz, it gives me the grbl menu just no actual motion control.
re-read the instructions a few times and then started trying to trouble shoot.
Power adapter is plugged in (green light is on the power supply but I havent tested the voltage output), serial over usb is working and creation workshop is connected (also verified serial coms with coolterm and the arduino ide).
helpz.
no motion from Z axis
Re: no motion from Z axis
just vetted the power supply. a solid 12.25 volts.
resetting the device power and ? shows the shield is in alarm mode. $X to reset and then $h still yields no result. currently idle with no motion.
resetting the device power and ? shows the shield is in alarm mode. $X to reset and then $h still yields no result. currently idle with no motion.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: no motion from Z axis
Hi Travis,
Email me directly at info@junction3d.com
I can connect to your pc remotely tomorrow morning and help diagnose the issue. I'm sure it's something simple, because we test these machines extensively before shipping them.
-Emil
Email me directly at info@junction3d.com
I can connect to your pc remotely tomorrow morning and help diagnose the issue. I'm sure it's something simple, because we test these machines extensively before shipping them.
-Emil
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: no motion from Z axis
Thanks Emil,
I shot ya a line.
I shot ya a line.
Who is online
Users browsing this forum: No registered users and 61 guests