Had a power outage while printing.
The plate is stopped down in the vat.
How do I get the plate back up out of the vat?
I am afraid if I hit home it will impact the vat and damage the printer.
I now have a battery backup so this won't happen again.
get the build plate out of the vat.
-
- Posts:2
- Joined:Tue Oct 31, 2017 3:24 pm
- mongerdesigns
- Solus Guru
- Posts:1951
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: get the build plate out of the vat.
Turn the power off from the back, then open the lid and turn the lead screw by hand until the arm moves up about half way up. Then remove the build plate and resin tank.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
-
- Posts:2
- Joined:Tue Oct 31, 2017 3:24 pm
Re: get the build plate out of the vat.
That was easy!!!
Thanks so much!
Thanks so much!
Who is online
Users browsing this forum: No registered users and 6 guests