Can someone provide the instructions for replacing the film diaphragm? It would be appreciated.
Toddmichael
Vat Diaphragm Replacement Instructions
- toddmichael
- Novice
- Posts:77
- Joined:Sun Jul 05, 2015 4:33 am
- Location:Motor City, Mi
Toddmichael
Firestorm Cad / Jeweler / Designer
Firestorm Cad / Jeweler / Designer
Re: Vat Diaphragm Replacement Instructions
Hi Todd,
I emailed you instructions and I will add them to the manual once I create a nice diagram.
I emailed you instructions and I will add them to the manual once I create a nice diagram.
- toddmichael
- Novice
- Posts:77
- Joined:Sun Jul 05, 2015 4:33 am
- Location:Motor City, Mi
Re: Vat Diaphragm Replacement Instructions
Instructions per Mark for changing the Vat Film.....
Mark "Changing the film is pretty straight forward but a couple things to remember... please do not over tighten the screws and the film should be loose enough that the vat sits less than 1 mm above the top plate before the thumb screws are tightened. You can stretch the film by hand if it is too tight. The film should just be pulled tight in the last couple rotations of the thumb screws. You can run your finger around the edge of the film (between the vat wall and the quartz) to loosen the film a bit if it's too tight and sitting too high."
Toddmichael
Mark "Changing the film is pretty straight forward but a couple things to remember... please do not over tighten the screws and the film should be loose enough that the vat sits less than 1 mm above the top plate before the thumb screws are tightened. You can stretch the film by hand if it is too tight. The film should just be pulled tight in the last couple rotations of the thumb screws. You can run your finger around the edge of the film (between the vat wall and the quartz) to loosen the film a bit if it's too tight and sitting too high."
Toddmichael
Toddmichael
Firestorm Cad / Jeweler / Designer
Firestorm Cad / Jeweler / Designer
Re: Vat Diaphragm Replacement Instructions
And avoid cleaning the film with a paper towel as it can scuff the film.
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Vat Diaphragm Replacement Instructions
Could you send those instruction to me also.
Thanks
Mike
Thanks
Mike
Who is online
Users browsing this forum: No registered users and 5 guests